Setra-system Model 231RS Manuel d'utilisateur télécharger pdf (Page 13)

3.3 Remote Sensors Installation

Armored Cable Version (P/N: 231GRSXAJXXXX)

For Armored Cable version remote sensors, use the following instructions:

1. Install the remote sensors into the system plumbing (use 3/4” hex to tighten”)

Important:

Each remote sensor is labeled “HIGH PRESSURE SENSOR” or “LOW PRESSURE SENSOR”, respectively. Match up

the high pressure sensor to the high “HI (+)” pressure electrical terminals, and the low “LO (-)” pressure

sensor to the low pressure electrical terminals. Otherwise, the performance may not meet the product

linearity specications.

2. Attach the cable provided to the 3-Pin Packard connector on the remote sensor.

3. Feed the cable through the PG tting on the bottom of the unit and tighten the tting.

4. Remove the terminal blocks from the circuit board and use the following chart:

Important: Prior to putting the unit into service, complete conguration setup in Section 4. After conguration is

complete, press the “Zero” button.”

Top View: Hirschmann Connector

Type: G4A1M#931807-106

1/8" NPT

2.24

56.9

0.29

7.4

1.38

35.1

3/4" HEX

OPTIONAL HIRSCHMANN CONNECTOR

Type: G4A1M #931807-106

1.62

41.2

Chart 3. Electrical wiring color chart for

High & Low Pressure sensors (Armored

Cable version)

1 2 ... 8 9 10 11 12 13 14 15 16

Pas de commentaire

Setra-system Model 231RS Manuel d'utilisateur Page 13