Setra-system Model 230 Manuel d'utilisateur

1Installation GuideModel 230Wet/Wet Dierential Pressure Transducer1-800-257-3872 Toll Free1-978-264-0292 Faxwww.setra.com Web Site

106.0 LIMITED WARRANTY AND LIMITATION OF LIABILITYSETRA warrants its products to be free from defects in materials and workmanship, subject to the fol

11SS2010 Rev. J 4/4/14

12

21.0 GENERAL INFORMATION ... 32.0 MECHANICAL INSALLATIONS ... 3 2.1 Media Compatib

3Setra Model 230Wet/Wet Dierential Pressure Transducer1.0 GENERAL INFORMATION Every Model 230 has been tested and calibrated before shipment. Setra

42.6 Installation Procedures If the Model 230 is supplied with an optional 3-valve or 5 valve manifold assembly, refer to Section 2.8 and 2.9. Option

52.8 Optional 3-Valve Manifold ProcedureThe 3-Valve Manifold Assembly is normally shipped with valves V1 and V2 closed and V3 open.To place the Model

62.9 Optional 5-Valve Assembly ProcedureThe 5-Valve Manifold Assembly is normally shipped with valves V1, V2, V4, and V5 closed, and V3 open.To Place

73.0 ELECTRICAL INSTALLATION To access electrical connections remove cover on top of the Model 230 For CE compliance a shielded cable with both ends

84.0 CALIBRATION The 230 transducer is factory calibrated and should require no eld adjustment. Whenever possible, any zero and/or span osets shoul

94.3 Current Output Zero Adjustment While monitoring the current output, and with both pressure ports open to atmosphere, the zero may be adjusted. F