Setra-system Model SRH Manuel d'utilisateur télécharger pdf (Page 3)

3.0 ELECTRICAL INSTALLATION

3.1 Wiring

Match your transmitter with the corresponding diagrams and set the jumpers and wire

accordingly. Ensure that all of the installation and wiring is in compliance with all national

and local codes. Use 18-22 AWG shielded, twisted pair, copper conductors.

Caution: Do not bundle transmitter wires with AC power wires. Shield must be connected to

earth ground for CE compliance.

Wall Mount

Connector/Jumper Locations - Inside cover

Duct and Outside Mount

Connector/Jumper Locations - Board Assembly/Duct Probe

1 2 3 4 5 6 7 8 ... 11 12

Pas de commentaire

Setra-system Model SRH Manuel d'utilisateur Page 3